In Vacuum Subminiature 9 Pin C Type Cables£ 58 – £ 354 TECHNICAL SPECS – CLICK HERE In Vacuum Subminiature 9 Pin C Type Cables UHV Cable Assemblies In-vacuum cables for C type feedthroughs are available in two configurations: Round cable assemblies consisting of 9 wires bound with PEEK braid into a round bundle and fitted with PEEK C connector, or ribbon cable assemblies consisting of 9 wires woven into a flat ribbon using a PEEK weave thread and fitted with PEEK connector. Both types are supplied as standard with connector fitted one end and the opposite end being non terminated. Round cables are colour coded for ease of identification. Both round and ribbon cables are also available fitted with female crimp connectors (without PEEK housing) one end with the opposite end not terminated. These cables will not allow subsequent fitting of connector as wire must be threaded through connector back prior to crimping contacts. Stated electrical ratings are maximum test values. Feedthroughs are intended for instrumentation applications carrying low level signal voltages and currents. For proper heat dissipation a maximum of 20% of the pins on a feedthrough may carry the maximum current at any one time. Extension cables, with female PEEK connector fitted both ends are also available in both round and ribbon type cables. Features: • 9 wire, 7 x 0.127mm (28AWG) configuration, either round or ribbon. • PEEK braid outer or weave. • UHV compatible. • Custom lengths available. Specifications: Voltage1 : 600VAC, 2kVDC max Current1 : 2A Material Conductors : Silver plated copper. Insulation : Type F Kapton® film Braid / weave : PEEK In-vacuum connector3 : PEEK Temperature Range2 : -75°C to 250°C Kapton® Properties Dielectric constant : 2.9 Dielectric strength : 80kV/mm Dissipation factor, 1MHz : 0.002 Initial tear : 13.4kg/mm Elongation : 50% Moisture absorbtion : 0.4% @ 50% RH Radiation resistance : 109 Rads ______________________________________ 1 – Please see section introduction for safety information. Stated electrical ratings are maximum test values. Feedthroughs are intended for instrumentation applications carrying low level signal voltages and currents. 2 – Assembly rating is reduced to that of the lowest rated component. 3 – PEEK is a polyetheretherketone thermoplastic. Ceramic in vacuum connectors are also available, please contact sales office for details. Product CodeLength (mm)Cable TypeConnector TypePriceQuantityPDF & STP C9-VCF500 500 Round Female £ 166 Add to quote STP C9-VCF1000 1000Round Female £ 198 Add to quote STP C9-CXFF500 500 Round Female / Female £ 327 Add to quote STP C9-VCM500 500 Round Male £ 188 Add to quote STP C9-VCM1000 1000Round Male £ 224 Add to quote STP C9-VCFP500 500 Round Female pins only £ 58 Add to quote C9-VCFP1000 1000Round Female pins only £ 94 Add to quote C9-VCMP500 500 Round Male pins only £ 58 Add to quote C9-VCMP1000 1000Round Male pins only £ 94 Add to quote C9R-F500 500 Ribbon Female £ 205 Add to quote STP C9R-F1000 1000 Ribbon Female £ 259 Add to quote STP C9RX-FF500 500 Ribbon Female / Female £ 354 Add to quote STP C9R-M500 500 Ribbon Male £ 205 Add to quote STP C9R-M1000 1000 Ribbon Male £ 259 Add to quote STP C9RL-F500 500 Ribbon Female pins only £ 79 Add to quote C9RL-F1000 1000 Ribbon Female pins only £ 130 Add to quote C9RL-M500 500 Ribbon Male pins only £ 79 Add to quote C9RL-M1000 1000 Ribbon Male pins only £ 130 Add to quote SKU: N/A Category: Subminiature C
